| Engine |
Kubota V 2003 T, 2.0 liter diesel, 4 cylinder, 4 stroke, turbocharger, water cooled, 61 HP @ 2800 rpm.* |
| Electrical |
12 V 90 A alternator, 88 Ah high capacity cold-start battery. Turn off using ignition key. Central electronics panel. Revolution counter. |
| Transmission |
Infinitely variable hydrostatic drive, which can be changed under load, with automotive control. |
| Speeds |
Slow range 0 to 12 km. Fast range 0 to 40 km. The whole speed range can be selected using the multi-function drive lever for both forward and reverse drive without any interruption of the transmitted power. |
| Power take-off |
Single dry clutch plate (with asbestos free linings) for independent PTO shaft operation. Front and rear PTO shafts can be engaged under load. Standard 1
3/8", six splines. Rotation speeds: front 591 rpm, rear
610 rpm. Rotation clockwise (viewed from end of PTO shaft). Rear and front PTO can be fully loaded. |
| Axle drive |
4-wheel drive with differentials on both axles, rear axle always engaged, front axle can be hydraulically engaged. Front and rear differential locks electro-hydraulically pre-selectable (engage automatically when wheels spin, disengage when no load is present), status indicator light. 100% locking. |
| Steering |
Hydrostatic 4-wheel steering based on load sensing system. Front wheel steering pre-selectable via push button. The automatic sensing and synchronization of the wheel positions using inductive sensors makes it possible to change the steering mode at any time, even while in motion. Turning radius 2.90 m. |
| Tires |
Low pressure Terra tires, 31x15.50-15.4 PR. Diameter 782 mm, width 351 mm. |
| Brakes |
Foot brake: hydraulic servo brakes operating on all four wheels. Hydrostatic driving brake. Handbrake and independent wheel brakes: mechanical servo-assisted brakes operating on rear wheels. Linings free of asbestos. |
| Driver's cab |
Vibration damped driver's cab. OECD approved roll guard (ROPS) with front windshield and opening roof. Comfort seat. |
| Hydraulics |
175 bar. Flow rate 24 l/min @ 2800 rpm. 10 l oil reservoir for auxiliary hydraulic cylinders. |
| Front hydraulic linkage |
3-point cat. I. Lifting power: 1200 kg. Controlled using seat valves with the functions raise, carry, lower, float position, weight transfer, side shift. The complete linkage can be displaced hydraulically by 20 cm to the left or right. All functions selectable using the multi-function drive lever. "Weight transfer" function, infinitely adjustable. Quick action couplings on the lower link (pick-up hooks). |
| Rear hydraulic linkage |
An optional extra: 3-point cat. I + II with lateral stabilizing chains and top link. Lifting power: 1000 kg. Controlled using seat valves with the functions raise, carry, lower, float position, weight transfer (infinitely adjustable). Lifting arms with crank adjustment (adjustment range 100 mm). |
| Auxiliary hydraulics |
Version 1:
Two connectors at the front and rear for double-action cylinders (including float position).
Version 2: One connector at the front and rear for simple-action cylinders. |
| Drawbar |
Ø 26 mm, 27 cm above the ground. |
| Fuel tank |
62 liters |
|
Weights |
Weight (without rear hydraulic link) |
1650 |
kg |
| Max. permissible front axle weight |
1800 |
kg |
| Max. permissible rear axle weight |
1800 |
kg |
| Max. permissible total weight |
2950 |
kg |
| Trailer coupling load max. |
400 |
kg |
| Trailer weight (with brakes) max. |
3500 |
kg |
| Trailer weight (without brakes) max. |
600 |
kg |
